iFixit Desoldering Wick - 2.5 mm Width
Desoldering braid, 2.5 mm wide and 1.5 m long, absorbs excess solder, for PCB repair and rework, suitable for tight contact points
The iFixit Desoldering Wick cleanly removes excess solder from circuit boards and component contacts. It is suitable for repairs, rework, and precise electronics work where controlled desoldering is required. The no-clean flux coating supports quick solder absorption and reduces additional cleaning effort after work.
- No-clean flux coating supports clean desoldering without extra cleaning steps
- 2.5 mm width provides a good working area for circuit boards, pads, and typical electronics repairs
- 1.5 m length provides enough material for many repair and rework tasks
- Fast solder absorption efficiently removes excess solder
- Flexible copper braid conforms to contact surfaces and facilitates work in tight spaces
Efficient desoldering for electronics repairs
During rework on circuit boards, excess solder must be removed quickly and precisely. The iFixit Desoldering Wick reliably absorbs solder and helps you cleanly prepare pads and contacts. This makes it easier to replace components or correct solder joints.
No-clean coating for less rework
The desoldering braid is coated with no-clean flux, supporting even solder absorption. This saves time because less cleaning is needed after desoldering. Especially in fine PCB work, this keeps your workflow clean and efficient.
Compact format for workbench and toolkit
With a width of 2.5 mm, the braid is suitable for many typical soldering and desoldering tasks on electronic components. The length of 1.5 m provides enough reserve for repeated use. This makes it a good fit for any repair setup, from a stationary workstation to a mobile toolkit.